Bosal 265-827 Pipe Connector
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
One and a half of an inch
There is a split sleeve within this clamp which may have caused this clamp to fail. I used this clamp for my VW exhaust and it worked fine. There will be leaks if that is the case. You asked about tube whose ID or OD matched your existing pipe (say a length of 6"? that can be used This clamp, or any other clamp(s) can then be used.
Selected User Reviews For Bosal 265-827 Pipe Connector
As a result of the review by another VW owner, I was fairly sure it would fit my car. Still, I wasn't entirely sure what to do. This is the awning I put in my Minnesota driveway today (I don't have a garage) and it's approximately Right now, there are 20 out. In fact, yes. You're right, that's ok. Anyway, I'll tell you how it goes. I did not have any pipe measurements before ordering, and this product does not have any specifications listed for it. In order to install the tires, I jack up the vehicle and measure the diameter with calipers. It's the right size! (and it's right size!)
My VW Center Pipe. (between muffler and engine)
Outside Dimension
A 55mm lens. This Bosal pipe connector measures to about 2 1/8 inches INSIDE dimension before anything is tightened. My two separated pipes slid beautifully over this and I was able to use my DeWalt impact driver with a 17mm socket to secure it in place. It comes equipped with the lock washers I needed and looks very well made. 107,800 kilometers have been clocked up on my VW. I found this to be an excellent design and I have a normal sound level again in my car! JcWHitney's website includes various charts for compatibility, despite the fact that each vehicle may have a different make, model, and year. would like to offer this to a future VW owner too!.
The clamp is 55mm in diameter and is used to attach the down-tube In a 2000 Audi A4 (B5) quattro sedan, I have an exhaust pipe to the center muffler. I bought the first one on February 13, 2016 and it is rusted out and leaky from the seams. Replace it with another when it arrives. We didn't expect it last as long as it does, but for $3 a year, we can't complain. In the event that stainless steel is offered, I would not mind paying more.
It was much larger than what was expected to connect the resonator section to the muffler section, despite their promise of a perfect fit. Larger than the connection from the center section to the flex pipe as well, which is also larger than the area where these are supposed to be installed. The design is similar to that of original equipment, but is obviously.
Everything seems to be in order - I made it My car had an aftermarket exhaust system installed by the previous owner This exhaust did not fit the aftermarket exhaust with an OD of 2". These nuts are mounted on sockets that are 17mm in diameter. It may fit the OEM VW exhaust system it will not fit 2" OD exhaust pipes, but it might work for 2" ID exhaust pipes.
It took 10 minutes for the repair to be completed.
I got a perfect fit because my old clamp was rusted straight through and fell With this clamp it was super fast delivered to me the next day, I installed it, and haven't experienced any problems since then.
I still have it sitting on my.
The clamp sealed the elbow joint on my new Magnaflow exhaust like a champ after I had my doubts about it.