Yukon Gear & Axle (YY STR-004) 1310/1330 U-Joint Strap with Bolt for Dana 30/44/AMC Model 35/Chrysler 9.25 Differential
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
On my 1999 Dodge RAM Sport 1500 5, I have a Dana 45. 9l, as well as the u- Although the bolt straps were slightly too large, the bolts themselves were perfect. They might work for a Dana 30 but I'm not sure about that.
No, it will not.
I'm the proud owner of a 1982 CJ-7. They're 7 in number, and they're compatible with all of the driveshaft's connecting points. So yes!
Yes, they will fit on your Jeep (mine is a 1999).
Selected User Reviews For Yukon Gear & Axle (YY STR-004) 1310/1330 U-Joint Strap with Bolt for Dana 30/44/AMC Model 35/Chrysler 9.25 Differential
I needed new hardware to install my 85 Corvette rearend in a 1957 Chevy pickup, and these fit perfectly. Knowing Yukon Gear, I was confident that these would fit perfectly, and they did. Because the bolts came with loctite, I simply chased out the tread holes and installed them. When tightening, keep in mind that these bolts are only 1/4x20, so don't overtorque them. Excellent value for well-made components.
Spicer U-shapes are all they are. Joint Straps of excellent quality, but not as described in the product description. The pinion yoke on my 1988 Jeep Comanche fit perfectly.
I had to replace the u-joint on the rear shaft. After experiencing drive train vibrations, I decided to replace the joints on my 1999 Jeep Cherokee. On the yoke, I discovered two old strap bolts that had become a little rusted. I'm glad I got this kit because it's recommended that I replace them with new u-bolts. installation of a joint The straps were replaced with this kit from "Spicer. " It is labeled differently, but it is Spicer quality. Yukon (YY STR-) is a Yukon (YY STR-) is a Yukon ( U- (004) 1310/1330 U- (004) 1310/1330 U- (004) 1310 Strap around the joint).
It couldn't thread into the yoke because there was something tough on it. It was like a thick goo on all of them at the same time, and I had to re-chase the threads to clean them up. That is, however, something I should not be required to do.
All of the u-bends have been replaced. My front and rear driveshafts have a number of joints that need to be replaced. My Jeep Cherokee xj 2dr 4 is a 1989 Jeep Cherokee. 0 AW4/231 with a Dana 30 from HP and a Dana 35 from Dana 35 from Dana.
If you're looking at it, it's likely that you'll need two sets. You might as well do it- While you're at it, throw some joints in the mix.
They weren't what I was expecting at first, and they didn't appear to fit, but they did.
The part with Spicer is fantastic. OEM is the same.