* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
YAMAHA ENG-METER-4C-01 Deluxe Hour Meter

YAMAHA ENG-METER-4C-01 Deluxe Hour Meter

YAMAHA ENG-METER-4C-01 Deluxe Hour Meter
$ 59.95

Score By Feature

Based on 40 ratings
Easy to install
9.48
Value for money
9.49

OveReview Final Score

How Our Score Is Calculated

Product Description

RHINO GENERATOR HIGH Performance & HOURS METER ATV DIRTBIKE RHINO METER

Questions & Answers

Do you know whether this will work for a Yamaha ?

An outboard motor has the potential to work with this.

Is this going to work on a Yamaha TT A dirt bike with an R110E engine?

Although I don't see any reason why not, contact the seller or manufacturer for confirmation.

Do you think it would be possible to extend the wire? What would the extension cost?

As far as we know, you can use a special single wire with a voltage of no less than 0.6 volts and no more than twice the length. It is not battery powered and uses electricity from the spark plug wire so limits its use. You may want to check with the manufacturer to find out whether longer wires are available.

Does it work with a Yamaha f115 outboard and does it show the amount of engine hours it already has?

Prior to installation, this software is not able to determine engine usage, but otherwise, it should function. If you are interested in purchasing, contact

Selected User Reviews For YAMAHA ENG-METER-4C-01 Deluxe Hour Meter

Meter that is easy to install and of high quality
5/5

A Yamaha EF6300iSDE generator is what I purchased this for. My solution was to drill a small hole on the left side panel, just above the vent slots, to run the wire through, and to screw the meter in place with two To do this, wrap the wire around the spark plug wire as close as possible to the spark plug boot. Make sure that you wrap the wire around the plug wire at least five times, keeping the windings close together, and then tie it in place with a zip tie (wire Some people have previously asked whether the rubber sheathing from the spark plug wire needs to be removed in order for the meter's wire to be wrapped I strongly recommend that you do not remove the rubber sheathing from the spark plug wire. The meter wire should wrap over the rubber sheathing. I was looking at yet another one for my MTD Yard Machines snow blower, but I'll probably end up cutting off the extra wire, or coiling it up and cabling it inside the generator, motorcycle, snow mobile, etc. I think it will last for a long time because it does what it is advertised to do.

Raina Snider
Raina Snider
| Apr 03, 2021
I've edited it I changed the wire and it now I've edited it I replaced the wire and reinstalled it We've installed it
4/5

I am now able to use it. There may have been an error in the way I inserted the data into the meter. Thank you for your review and apologize for the negative feedback. This is a review from a long time ago The Yamaha 250 4-way system has been installed as per the instructions The outboard motor is a four-stroke The motor was run for about 15 minutes on the hose. There is no change in the reading on the meter. Since it needed a minimum of 0, I thought it would be a 1. The difference in 15 minutes would at least be noticeable in 1 hour. There is nothing. It would have been better if I gave it zero stars, but that is unfortunately.

Marlowe BURROWS
Marlowe BURROWS
| Oct 15, 2020
It is well equipped with an hour meter and tachometer
5/5

This is the one I used on my Generac 17 years ago and it is still going strong. Just a few weeks ago, I put one on my 25hp out board. This is a very simple and easy-to-install product.

Octavia Obrien
Octavia Obrien
| Jan 01, 2021
An hour meter that is perfect for the job
5/5

I can install it in a few minutes. In order to keep track of how many hours have been spent on each of my machines, I purchased a timer for my brand new Yamaha superjet.

Bryant Goodwin
Bryant Goodwin
| Sep 29, 2020
The product is easy to install and works well
5/5

The generator was connected without the need for any software to run. As soon as I took off the back cover of the engine, I measured the length of cable I needed. I cut the provided cable accordingly, wrapped it around the spark plug wire, and routed it up through a pinhole I punched in the rubber cover of the spark plug. In order to secure it, I used two provided screws and mounted it on the exhaust side just above the handle.

Lucca Burgess
Lucca Burgess
| May 04, 2021
The fit is tight
4/5

It does what it is advertised to do. My Yamaha 2000 has been fitted with this. Wrapping the wire around the spark plug wire is notoriously difficult. You may need some needle nose pliers or something similar to do the job. A gauge of this type should have been standard on the unit, as it makes sense logically. The gauge already installed on the generator is not going to set you back much more than a few bucks. It is for this reason that four stars are available.

Julie Middleton
Julie Middleton
| Sep 30, 2020
It was exactly what we The product came in its original state
4/5
Brynn Wilkinson
Brynn Wilkinson
| Feb 04, 2021
Tools to toolbox tach
5/5

In order to set the idle on my Husqvarna chainsaw, I purchased this item. By doing so, I was able to get an accurate result without dividing or multiplying. I loved how easy it was to set up Take continuous readings by inserting the wire and wrapping it around the spark plug wire several times.

Giselle Mendoza
Giselle Mendoza
| Oct 18, 2020

Related Products For YAMAHA ENG-METER-4C-01 Deluxe Hour Meter