2FarOffRoad | Key-on power harness for Honda Pioneer, Honda Talon UTV's.
Score By Feature
OveReview Final Score
Questions & Answers
Yes, a standard UTV horn will be powered by this. Thanks.
Yes, this is most likely a ten-minute film. Maximum current draw is 15 amps. br>A small light bar may suffice, but anything longer than 14 inches needs to be controlled by a relay. br>You'd then use that as the switch's relay trigger power.
Yes, it is compatible with all Pioneer and Talon models.
I have it connected to a small positive block for accessory applications that require only power. in the case of a normal current or load - I get power from the battery through a direct (fused) connection. The'stock' 10amp fuse, which powers the outlet, is the only source of power for this - which, yes, is still functional. It could be improved, but the wires are too small to carry much weight in the first place. I hope this has been of assistance.
Selected User Reviews For 2FarOffRoad | Key-on power harness for Honda Pioneer, Honda Talon UTV's.
This was a total success! Thanks to those who responded to my questions about using a relay to connect this to a light bar, I now have power. Instead of building your own harness, I recommend getting a plug and play setup from Amazon. I saved almost $20 by doing so, and the lights work perfectly. Thank you for your support, SXS Club!.
br>Remove the 12v cigarette socket by unscrewing it. Go inside the cab and attach the harness through the passenger side. Maintain a tight grip on the retaining nut. After that, exit the cab and tighten the retaining nut. Tighten the nut while holding on to the accessory wire.
It's very simple to reach behind the rubber flap and through the hood. Remove the 12v outlet only if you have to. It's a breeze to unplug from the back and plug in this plug-and-play harness.
To install this wire harness on my Honda Pioneer, I had to remove the entire front clip, including the battery, and disconnect the fuse box, battery, and everything under the hood. It's a good thing I had long arms.
In my Honda 1000 SXS, I used it to install an auxiliary battery.
It was simple to install, and there were no wires to splice. So my brand new Honda Pioneer 1000 is still a brand new Honda Pioneer 1000! br>Excellent customer service, including installation videos. For anything you need to know about your sxs, the Hondasxs forum is also a great place to go.
It's very simple to set up, just plug it in and go!.