Rear Brake Caliper Repalcement for 80t Mid XRS XRX Go Kart 6.000.028
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It has a diameter of 10mm and a length of 28mm.
Yes, you can see it in the fourth picture of the listing, and it will keep the brake pads in good condition.
Yes, but it does not fit the Trailmaster Mid XRX as stated in the description. I ended up ordering one from the same place I bought the go kart so I could be sure it would fit and not be stuck with more useless Chinese junk.
Selected User Reviews For Rear Brake Caliper Repalcement for 80t Mid XRS XRX Go Kart 6.000.028
The caliper is exactly that, nothing special, and it performs as expected. It's the pads that are causing me problems. To begin with, the piston side's design is absurd. There is no clip, so the pad is only held in place by pressure. As a result, when it wears out, which happens fairly quickly, the pad will fall out of the assembly, causing the piston to overextend. This prevents the piston from being reset and can result in severe disk rubbing. My suggestion is to add a retaining clip for the pad, as well as a more durable wear surface, as they are wearing out far too quickly.
Easy to install, good product value for the money, and overall a nice break Caliper for the Hammer head 80T mid size go karts, also no tool required to bleed the breaks, simply unbolt your old breakline, then caliper, and bolt in your new break caliper using the same bolts! Replace the breakline bolt with a new one that comes with a new caliper. Now, there is a smaller bleeder insert that looks like a grease insert, unscrew that just enough so it won't fall out but won't hold pressure back, then get some break fluid, and pump the breaks until you see break fluid coming from the bleeder insert, then tighten bleeder insert and fill break fluid to required ammont, in break fluid reserve, pit cap back on, and breaks should work, not as you pump the breaks tho.
Rebuild your cart. Despite over a quart of brake fluid running all the air out of the brake line, the brake pads simply fall out, and the caliper only expands about 1/3 of the distance it should, I'm extremely disappointed with the quality and design.
Fast shipping, it took a little time to install, and if you're going to replace this one, you should replace the master cylinder as well.
To apply brakes, the piston does not compress. Is there a reason for this problem? Is it possible for me to be reimbursed or to be sent one that works? That would be fantastic.
Although the product appears to be of high quality, I am unable to get the system to bleed. I haven't put much time into it.
Simple to set up, and it works perfectly!.
Great.