SAUTVS Rear Windshield for Ranger XP 1000, Lightly Fullsize Hard Rear Window for Polaris Ranger XP 1000 / Crew XP 1000 / Diesel/XP 900 2017-2022 Accessories(Compatible with Roof)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It would be very comfy for me to ride a trailer with a windshield and a
This accessory fits the Ranger XP 900 2014.
As long as I don't have a front windshield installed, I won't. I'm afraid not. Removing or installing the rear window only takes about 20 seconds, and you could store it in the tow vehicle for later use. I never thought I'd spend this kind of money but it was worth it!
The 2018 Ranger XP 900 can use these tires.
Selected User Reviews For SAUTVS Rear Windshield for Ranger XP 1000, Lightly Fullsize Hard Rear Window for Polaris Ranger XP 1000 / Crew XP 1000 / Diesel/XP 900 2017-2022 Accessories(Compatible with Roof)
My first point is that I rarely write reviews unless it is for warning people about Due to this windshield only having a few reviews and the fact that I was so impressed with it, I thought I would give some feedback. It was packaged well with foam, bubble wrap, and the sticky paper attached to the windshield as well. I was so surprised by how well the shoes fit. I have a 2021 Ranger 1000 Premium (which is the same frame area as an XP) and it fits just fine. As it turned out, it only took me less than 30 seconds to install it once This was already ready for the end user, but usually the end user would have to install weather stripping and hardware. Upon dropping it onto the frame, the bottom brackets are applied and then it's twisted slightly on the 3 top knobs to snug it up. When you compare this with Polaris, I'd choose it over the Polaris brand The seller of the windshield and the manufacturer of the windshield are unknown to me, so I have no connection to either one. I am being completely honest in this.
I appreciated the way it was packaged. It is easy to mount the unit once you open the box, peel off the protective film, and mount it. Taking off the film took the longest amount of time, but it was not too In reality, I needed to spend more time heating up the garage for what I had thought would be a 30-minute assembly/installation. My jaw would drop if the process took longer than four minutes. As the lower edge of the rear windshield rests on the opening and the ROPS bar, you simply tilt the top in, and rotate the 3 clasps on the inside. That's all there is to There is an excellent seal between the gasket and cylinder. A rear windshield like this one would be a great choice over other options.
There is a good rubber seal on the window that prevents water from entering and makes the window vibrations quiet. In spite of having a front windshield, I was still getting grit in my eyes all the time when I drove my Bobcat 3400D (which uses the same exact "Lock & Load" system as my old one) The ride was so bad that I had to wear goggles every time I drove the Profit Cab in dry weather, as it was a fullsize Polaris Ranger XP 1000. In my expectation, adding a rear window would be similar to a windscreen found on convertible cars, which would reduce the amount of dirt and sand that I would get blown my way when driving, and so far, it has been quite successful. Now, when I need to get around the ranch, I can safely use my prescription glasses rather than goggles. It's too early to tell how scratch-resistant it is since I've only had it on a couple of months, but it doesn't seem to have scratched yet. There has been a significant reduction in noise from the engine (which is located right behind the cab) so that I can now hold a conversation at a reasonable volume while driving. With no doors on the cab, it's not so quiet that I forget the car is a diesel, but it's not as annoyingly loud as it was The vehicle now runs with a great deal more enjoyment thanks to a significant upgrade.
Exactly what I needed. It took less than a minute to install. Currently, I do not know how easy the cleaning process will be or how effective the scratch resistance will be. I have found it to be working.
Using this rear windshield on my 2021 Polaris Ranger 1000 is much easier than ever. We read MANY review comments that you had to install the ribs and how painful they were to install (both time and labor). It has the ribs already installed and the mounting clips are already attached. It's the perfect windshield to replace the damaged one. I removed the product from its packaging (which was very well packed during shipping) and it took only 15 minutes to install it. I would recommend it highly!.
My rear window arrived early, and it was easy to install. I am enjoying it so far.
Fits perfectly and is super easy to install.