Ranger Rear View Mirror, kemimoto UTV Rear View Mirror Compatible with Polaris Ranger 500 570 900 XP 1000 XP/Crew 2017-2022 with Factory Drop Down Mounting Tab

The vibration was a problem for me, as it was for so many others. I fixed it by wrapping a zip tie around the roof mount and stabilizing it (see photo). This took out 90 of the vibrations immediately and took only 60 seconds to implement.

Stephanie Gross

| Dec 28, 2020

The mirror fell off the ball joint while being installed. Because this was the last step, I didn't tighten the two scews. My daughter had a wreck on the buggy, and the old mirror shattered into small pieces and stayed intact like the tempered glass is supposed to. I'm replacing the mirror because it fell to the floorboard of my Polaris and you can see the result. This one appealed to me because it was made of tempered glass. I'm glad this happened because if I had installed and there had been an accident, I would have hated to find out the hard way that it wasn't the case. Those shards of glass could have wreaked havoc.

Sophia Kaplan

| Nov 02, 2021

We don't give a damn about it. It was very easy for my husband to install it.

Elora Rush

| Jan 27, 2021

This mirror is exactly what it says on the package. It arrived in excellent condition and on time. It was a breeze to put together and holds its place well. It gives you a nice wide view of the vehicle's back end.

Clara BIRCH

| Jul 18, 2021

IT PERFECTLY WORKS.

Colin Richards

| Dec 14, 2021

When I opened the bag of nuts and bolts, however, it was pretty obvious what went where, and I was able to install the mirror on my Polaris Ranger 900 XP in a matter of minutes.

Rylee Dorsey

| Apr 07, 2021

The reflection in the mirror is excellent. manufactured, and the included mounting bracket (which attaches to the stock mirror drop-in) is adequate. down tab), but there's something wrong with it. The mirror should be about an inch lower (at least for me) for a perfect fit. 5'7" is my height. Also, either the mirror requires more left-handed reflections or the mirror itself requires more right-handed reflections. Right adjustability is required, or the mounting bracket must be twisted slightly to the left. The view through the mirror is out of the right half of the rear windshield when it is mounted and adjusted completely to the left. It's a little bothersome. I'm going to make a slightly longer mounting bracket with a slight twist to it. The seatbelt bypass is in good working order. A jumper wire would suffice, but the factory-installed one is more convenient. It looks much better with the style connector.

Eliana O’NEILL

| Jun 07, 2021

Installed on my father's polaris with minor adjustments. I made an o- with rubber. Between the factory drop-down mount and this mirror mount, there are rings. While operating the utv, vibration is unavoidable, and you should expect some, so it would be fantastic if there was a better way to isolate that with this mirror. Although the instructions were adequate, they could have been better. If you don't use a stubby phillips screwdriver to tighten the screws on the studded mount, your mirror will droop and flop around, easily out of adjustment. I didn't want to overtighten it, so I made a few minor adjustments until it was perfect.

Finnegan O’CONNOR

| Dec 16, 2021