* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
2pc 7 2pc 7 2pc 7 2pc 7 2pc 7 2pc 7 2pc 7

2pc 7" Ultra-Slim Single Row Off Road CREE LED Light Bar [1530lm] [18W] [IP68 Waterproof] [12V - 24V] Fog/Driving/Work Lights for Trucks ATV Cars - 60 Degrees Flood Light

2pc 7 2pc 7 2pc 7 2pc 7 2pc 7 2pc 7 2pc 7
$ 21.95

Score By Feature

Based on 2,981 ratings
Mounting system
8.78
Easy to install
8.78
Brightness
8.68
Value for money
8.72

OveReview Final Score

How Our Score Is Calculated

Product Description

Your model number must be entered when this is applied.
There are six highly bright 3 watt CREE® LEDs installed in this light which results in a 1,200 milliwatt output and up to 6 watts per LED.
I will install this tough-looking off-road truck or ATV into your vehicle for a neat look on the side, which measures 14 inches in height and 8 inches in length.
This design is rugged and powerful and features a durable aluminum extrusion housing with shatter-proof shatter-resistant polycarbonate lens with the highest industry standard IP68 waterproof rating available.
ZERO POP SWIVEL MOUNTING BRACKET - With the swivel brackets in the upper part of this product, you can tilt your light angle as you wish so you will have the clearest light possible.
MODEL AVAILABLE IN RATED OF 60 flood light ght to either 60 flood light for larger area coverage or 30 spot light for a longer distance coverage on any kind of terrains.

Questions & Answers

Do these guys pull an Amps do these guys pull?

This is what original attendees thought about the number of amps this power would pull. Assume that nominal voltage equals 12 voltage volts d assume nominal 12vDC = 12. If 7vDC and 24vDC are connected, they should each output 25v. It is possible to approximate the approximate nominal Amp draw for both 12vDC and 24vDC system with four nominal circuits. They are 12/24 vDC-compatible lights. As a result, they are approved for use on computers. A rise in voltage is likely to cause a decrease in the consumption of Amps. Using a 24vDC system is more efficient than using a 12vDC system because they use more power per watt and their power usage will use x = 0 (). It is part of an electrical system that uses 12 volt power. The course of action seems obvious. - Poor crimps or wiring don't give us an advantage. As much as I care about size for the run to/from DC+ supply, length of a run, and if possible using a 3% Vd or 10% Vd table, the woman should be stated as much as she can. Numbers are tightly aligned sufficient - expressed in lable numbers are close enough - specified numbers are close enough - Due to these reasons, it is not possible for them to give you an accurate amount of the given amperage or milage.

are these possible fog lights? Will you feel comfortable nally does one well, will i not blind others? The headlights were upgraded after I upgraded my car, but seems to ed the headlights, but seems it didn't solve the problem?

In fact, they're very intense in color and are bright. It would also blind traffic. Using LED lights while fog-lit could be a good option if ambers are detected.

What have they done have they held up so far? Can you tell me if the wm in the lights? does a lit as bright?

The crop has been pretty good so far, and it hasn't gotten much moisture either. Lights like those on a side are common. I mounted my head light wraps up in my direction, pointing there for adequate lighting, which is not too much, but I like to use it, because I can wear my hair as much or as little as I want.

Would you be interested in sending me mounting brackets, that's what's mentioned in the specs??

I should have joined them once they arrived.

Selected User Reviews For 2pc 7" Ultra-Slim Single Row Off Road CREE LED Light Bar [1530lm] [18W] [IP68 Waterproof] [12V - 24V] Fog/Driving/Work Lights for Trucks ATV Cars - 60 Degrees Flood Light

It's really nice lights
5/5

I received exactly what I wanted - a small profile, high energy ratings, and a light that looks great. The following lighting options are suitable if you want to use these lights as trailer area illumination. I just installed these on my travel trailer, and it didn't take long to prepare the wiring. In order to protect myself from their arrival, I installed the porch dome light right next to my porch switch to prevent them from coming on right away when I turn it on. Installing it on the siding was handled as I ground it to a bolt and washer. A pleasant setting for enjoying drinks and to sit out with friends on the porch. Although I still need to buy another pair for the porch, however, it's working well so far. One complaint I had is that there is no comparison to being 360* rotating with the mounting system. I was pleased with these mounts if I did mount them in an angle. The vent fins of the light tend to stick out too far, which is why it is so far out that it will not rotate evenly if placed on a flat surface. The issue is not an issue since I did not have to mount it in that way.

Laylah Bridges
Laylah Bridges
| Aug 09, 2021
One 7” flood light bar
5/5

I drove these lights to work in my bumper to get dressed in the early morning. As for their size, they sparkle. I aim them to the ground for those that ignore them. In general, I have very good experiences with them. Since I had to order es, I had to go to tractor supply and buy longer bolts to mount them but that's no big deal. rated them five stars, so far I like it, but in the picture, the light bars on, with no headlights, are just the light bars. If it shuts off or if it drops out, that review will be updated. The two flood lights I bought cost $7.

Beckham Le
Beckham Le
| May 12, 2021
This model of Silverado will not be drillied in 2020
5/5

As a result of wanting more lighting at night while backing up my truck, I purchased these for my 2020 Silverado 2500HD. Upon making the purchase, I did not know how to mount them. Upon getting them, I checked under the back bumper to see if there were factory screws embedded in the lip, but I found no such thing. You remove two factory bolts and invert one bracket of the lights, your three sets of bolts will fit perfectly beneath the rear bumper, if you are making use of factory screws. What are the drill settings we're working with us drill! On my way home from work, I plugged them in to the reverse lights on the exterior. I didn't have any trouble with that part. Using a clamps, carefully place the reverse wires and LED lights in the reverse switch of the truck and pull out the rear light assembly. In reverse direction, the new LEDs' light will automatically turn on. The lighting seems to be quite nice. This should hold up, hopefully.

Amias Bird
Amias Bird
| May 13, 2021
Fantastic backup lights! There was no need to take them off the lawnmower until I fitted them under the rear bumper of my pickup afterward
5/5

Using my headlights on the back, I'm able to see up and down to back up just like the back-up truck.

Rex French
Rex French
| Jul 19, 2021
It looks great on the grill that is equipped with 2017+ standards
5/5

This tool fits right into my 2019 Toyota Superduty (Lariat). Mostly used as a setup for an additional set of Daytime Running Lights (more to keep you "see-in". There are also fog lights which work pretty well, but they don't light up enough during the night time to make their effects really effective.

Maverick Wong
Maverick Wong
| Jan 23, 2022
It was very bright, but the other one did not work - no
4/5

I like that replacement part that works great. These were given to me by my wife at Christmas. As a result of the defective product when I bench tested them, I had to take them out (in this case, I should have had 2. 5 stars) because I could not install the lights. 5*). In spite of its bright finish, the one that did work was not really that impressive. The housing is constructed of all aluminum with multiple large cooling fins. Several of the LEDs seemed to lack centered position while some appeared to have perfectly centered position on the reflectors. That did not appear to affect the blinding light's output. Upon returning the pair to Amazon, I have ordered a replacement box for them. Those replacements probably have an A rating because I hope I'll be able to give them an A rating.

UPDATE: Both of the replacement lights work, and they were quickly accepted. My Tahoe's backup lights come from these mounts to be used as extra back-up lamps for backing a utility trailer back up. They're pretty bright!! My backup LEDs #3157 were also replaced with Sylvania LED lights. The replacement lights greatly improved my rating. I could have rated them Five* for defective parts I received the first time. Yesterday, I installed both of them for me, but I cannot elaborate on how long they stay put or how long they last.

Jordan Miles
Jordan Miles
| Jul 20, 2021
Decent
3/5

Greetings, and welcome to our first impressions. The software hasn't been installed on long battery power yet. It is, however, impressive to see the results at close-up. The build is only mediocre, however. I am happy with them, the price was reasonable, and they look great, but I think they won't last forever. I also think I am very pleased with them, inexpensive, easy, easy-to-find and light. I was not surprised at all that this purchase was not as bad as expected. When it comes to the shipping, they send me two different reflectors: One has a nice flood, and the other has a higher heat, yet there is a lot of flood but mostly a very hot flood. Neither reflector housing was a problem, but I expected one would be. Look at what a sleek, stylish appearance it has. In short, it's a little bit of an okay year. In light of the fact they are only able to last two weeks, I believe I would go ahead and buy them again. In summary, I would say spending money on six of them surrounding one T-suit would be acceptable on a charter boat for nighttime fishing, and I believe they are good buys since they are being used on our charter boats for nighttime fishing. You can see the water by looking up.

Sevyn Bates
Sevyn Bates
| Feb 11, 2022
It's good quality
4/5

Getting a great experience from the quality. A nicely gauge of solid metal. They are quite lightweight due to their high quality and very strong shape. The installation is super easy. You can't go wrong with quality wires. The tilt isn't as difficult as you think as long as you tighten the bolts on both sides with a 10mm screw drill. As it turned out, our garage lights seemed pretty bright after being tested using a battery. Upon our rig being set up with our 12v system, I can't wait to see how bright it is.

Felix Moyer
Felix Moyer
| Jun 02, 2021

Related Products For 2pc 7" Ultra-Slim Single Row Off Road CREE LED Light Bar [1530lm] [18W] [IP68 Waterproof] [12V - 24V] Fog/Driving/Work Lights for Trucks ATV Cars - 60 Degrees Flood Light