Rapid TAC II Application Fluid for Vinyl Wraps Decals Stickers 4oz Sprayer

There is a statement on the bottle that it can be used in full sun. The only issue I have is that it dries before you can get the whole hood misted, but I blame the tiny nozzle on the 4oz bottle. While it might work great, it would be difficult to apply it all over your body with such a tiny bottle. The water from my garden hose ended up being sufficient to replace this stuff for me. As far as the vinyl hood wrap goes, I think it looks awful.

Flynn TALBOT

| Aug 08, 2021

I remembered that I had purchased some Lux tail light tints The installation of those was a real challenge since they stretched and warped a little as I attempted to put them in, so it was nearly impossible for them to align correctly. My first attempt at that project failed, but I decided to try again with this new tool available to me. Another set was ordered and using the slippery fluid made aligning the pieces a whole lot easier. I had time to properly align the pieces without stretching them I am very happy with the outcome. As the product goes a long way, I should have bought the smaller container and saved a few bucks, but all in all I'm happy with it.

Navy McCarty

| Oct 16, 2020

TAC does not apply to this crap The water I bought was green, which I think I bought. I followed instructions exactly, even had my husband do it to verify I followed them correctly. He followed instructions as well and got the same outcome as me. Water colored with dye is all that's in this stuff. The book is being returned to me. Here is no point in wasting your money.

Rebecca Bowman

| Mar 11, 2021

A few things to note about the product it Prior to using RapidTac II, I prepared using RapidTac Prep. It does allow you to position graphics and set them later. The only problem is you are not able to slide them around, you have to lift and reposition them Describe the situation. Graphics that are very large do not pose a problem. In the past, I have used it on graphics for race cars that were large and managed. My preferred method of using Slide-On will likely be from Phoenix or Classic in the future.

Eddie Shannon

| Sep 01, 2020

This is awesome You don't care more what it is, and you don't know To my mind, it works great with vivid pro carbon wrap - if that's what matters to you. You don't want to scrimp and use 'other' stuff instead of the wrap. Despite the fact that it has been outside for 3 months since the wrap was installed, the wrap still looks great. In general, I tend not to rate mediocre products, only those that are really good or truly awful. That's all there is to it.

Tomas Wilkerson

| Apr 09, 2021

These have been used to clean the surfaces of the door sills of a Honda Passport. It should then be applied generously to the surface as well as the back of the decal. It took me less than 3 minutes to finish. The directions on how to remove air bubbles with a squeegee were exactly what I needed. It was amazing how fast it took to remove what little air bubbles there were. An investment that is well worth your money. The application of vinyl decals should be done by professionals.

Maryam Caldwell

| Dec 10, 2020

During my visit to a sign shop in Las Vegas (where I purchased Rapid Tac original) I was told that this material can be diluted up to ten times It can be a bit slimy at full strength, so I am going to dilute mine. When the weather is cold, this is the perfect solution for applying auto decals. I'm not sure about this one, but the original Rapid Tac functions as both a cleaner and an.

Magdalena SLATER

| May 03, 2021

When it comes to installing perfect graphics, this stuff and a heat gun are your best mates.

Jaxson Conway

| Mar 28, 2021