2pc 6" Amber Oval LED Trailer Tail Light Kit [DOT FMVSS 108] [SAE I6] [Grommet & Plug Included] [IP67 Waterproof] [Park & Turn Signal] Marine Trailer Lights for Boat Trailer RV Trucks

After a vehicle is stopped, it is possible to see every light brighter, even those that are bright already. You can see what I refer to by looking at the glares in the photos. The photos are not too clear, but look at them if you want to understand what I mean. You cannot help but notice them as you travel down the road. There is something uniquely appealing about them that has never been seen in other lights that I have I am finishing off my trailer with these full LED packages and they add to its distinctive appearance. For my 6X12 enclosed trailer, I am looking for another set of lights to replace the existing ones.

Rose Villanueva

| Oct 09, 2020

MONEY IS WASTE. DO NOT SPEND IT ON JOBSITES. LED lights are most commonly ordered because they are bright and they reduce power consumption. These lights may reduce your power consumption but they are not bright in any way. We bought these LED lights to replace existing 6inch oval incandescent lights on a rear bumper. Stock lights are going to illuminate twice as large an area as Here is a review I hope is helpful if you are looking for decent lights for a reasonable price.

Lillie Joyce

| Jul 27, 2021

They are great for the price, but it is worth noting that the color of the light changes. I placed them on my Kaufman wedge so the black is the ground, the green the right turn, and the red the It's not for these pigtails, no way. It is colour white that indicates ground, red that signifies brake/turn and black that signifies It took me a few minutes to update all four, so I went back and changed them again. I give it a one-star rating.

Sloan Griffin

| Apr 27, 2021

This is a great Several months ago, I completed a renovation of a utility trailer, including the installation of Based on a review of several sources, I found these oval LED's to be the most cost effective option. I like the bright colors, the sharp look, and the plugs, which are industry-standard. As a whole, these lights are very satisfying to me. It is cheaper to get two lights than most places want to charge for In some reviews, the light was noted by reviewers to be loose when mounted and concern was given that it could cause the light to fall The one I had worked pretty well as long as I installed it properly, but just to be safe, here is a A healthy dot of clear silicone caulk should be applied to the mating surfaces of the rubber gasket. allow you to fix it in place but also remove it the next time that you need it. On the rubber gaskets used for the trailer and on the gaskets used to hold the light to the trailer, silicone was used. This is a nice, solid set.

Alessia Osborne

| May 05, 2021

I replaced my boat trailer's leaking Truck-R brackets with it. You can use these LED lights in place of 60 series incandescent Despite the new lights having the same size as the old ones, the rubber grommet that came with them was much thinner and flimsier than those that came with the truck- Grommet of light weight. The new grommets went in the trash and the 40-year-old grommets went back in- Grommets made of light materials. I think these lights would be perfect for Grommets were not tight enough to hold the new lights so they simply fell out when I tried to use them. The wiring connector for the new lights was very similar to the one used for the trucks This connector has the same pin spacing as a Lite connector, however, the pins are offset. Had I been able to reuse my original wiring connectors, I could have made the installation so much simpler. To connect the new plugs, I had to cut the old ones off and wire them in. I did not think it would be a big deal, but the process took more time than it should have. Transport via truck. My new lights are brighter than my previous ones, which are pretty standard.
I'm happy with the result. I'm curious to see how the new ones hold up to the environment for 40 years like the originals.

Evie Wilkins

| Jul 18, 2021

If yours is shot (or if you are installing it for the first time), the kit even includes replacement connectors. It's only because the rubber grommets are thin and flimsy that I didn't give this product 5 stars. Their lights are nowhere near as tight as they could be. It took a screwdriver to pry the old lights out. It's practically effortless to put them in and take them My concern was so great that I had to shim one side of the slots. It doesn't look like they'll keep water out when it rains, so I'm not sure if they'll work. It looks like I can get a good pair of these for $5 at my local auto parts store. Grommets of good quality would have been worth more to me than a $5 more expensive kit. I have updated the 6/26 edition of this article. . . As part of my quest to determine why the lights are so loose, I have been in contact with the manufacturer many times. This light is . I measured everything out and it is 025mm - The width of the ribs has been decreased by 60" The new lights are approximately 80" shorter than my old ones. Using the flimsy grommets that came with them, it shouldn't be a surprise that the fit is My search for a better job will take me elsewhere- It is time to install the.

Ira NORTH

| Sep 25, 2020

As I installed the lights on my Ranger Trailer, they were set in at an angle, and I wasn't happy with the performance of the stock LED lamps. It was very difficult to see them. There are now two times as many LEDs on each side of the new lamp, and the running lights glow much better than before. As well as the stop and turn functions, the lights at the intersection are very bright. There are many types of LED bulbs available, but this type is the best to me. The only thing is that I still haven't tested them in the water to see if they are waterproof, but I'm sure they will be fine. Thanks for putting this on the market! In addition to that, the dielectric grease is great in the sockets for the pig tails, and there is tape to prevent it from leaking out, thus adding to the value of.

Cara Herman

| Sep 21, 2020

The brake light is particularly helpful when I ride with children. I bought one for my minibike and one for my go kart. The go kart is powered by a 12V DC battery setup, and the light is extremely There are between 9- 15 amps in the minibike's lighting coil, so it's anywhere from 9- 15 volts The engine speed determines the voltage of 14V AC. These sure do run off AC, even though I wasn't sure they would. There are some flickering problems as well, and the lights are not as bright as 12V DC. I think that is still a great improvement over the incandescent brake light I used to have, which used so much current that the headlight would I find that the headlight does not dim when I pull the brakes on the minibike.

Alaya Phillips

| Sep 21, 2020