Tow Ready 20505 Wiring Kit for 2 to 4 Brake Control System
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
A total of two bundles is available. A one is about the size of a dollar. The battery runs 10 feet to the cab, and there is about one 100 feet long. To run from the cab to the back of the vehicle, it should take 20'.
If you wish to run cable all the way from the dash to the hitch, you will need it or something similar. You may already have a controller installed on your vehicle Because many of them are already ready, you shouldn't need one. As part of the controller kit are the relay and the wiring that is required for the relay.
A blue wire runs from the trailer connector to the brake controller box at the back of your truck. The installation of this feature may need to be sought out, but nearly all trucks have In the game of Pos, black is the player. You can charge the battery with (+) on the red side. I) negative. It is located on the right hand side of the It is the brake switch that is attached to the red wire- The part between the brake pedal and the caliper. A diagram of the interior of the brake controller should be included, as well as plenty of wire and splices and connections. Each of the four wires going into your brake controller goes to a very specific place. This is a 12-gauge. It's necessary to have a minimum size.
16 gauge is what I believe it's
Selected User Reviews For Tow Ready 20505 Wiring Kit for 2 to 4 Brake Control System
In the end, the installation went clean, but more tie wraps are needed than what is provided.
I received connectors, a circuit breaker, and two lengths of 2 pair covered #12 cable. One of these lengths was 10 feet long and had There was a second length that was 18 feet long with white and blue.
As part of my modification to my Oddy, I added a second breaker and ran the wire throughout the floor trim under the driver's side.
Like me, you may have not always had a functioning 7-way plug with your factory tow package. I found this wiring kit to be helpful and the quality of the wire is excellent.
A high standard of quality was present throughout. It is particularly important to pay attention to the connectors provided. Wires are protected by a strong wire jacket, and there is high quality insulation around the wires. Our system has been in service for over two months and is doing a great job.
The brakes I wanted for my trailer were just what I needed.
The circuit is wired into the jeep's LJ. It has around 2 volts There are 3 feet of wiring left over. Prior to cutting the wire, we had to pull the wire.