Tekonsha 3021-P Brake Control Wiring Adapter for Dodge and RAM
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I just installed it on my 2019 Ram 2500 and it fits and functions perfectly.
It was a perfect fit for my 2015 Ram 1500.
No way, I don't think so.
The 3021 that I bought fit into a plug that was already in place on my 2012 RAM.
Selected User Reviews For Tekonsha 3021-P Brake Control Wiring Adapter for Dodge and RAM
Classic Warlock, 6 liters, 1500. My 2019 Dodge 4x4, Crew Cab, 3, according to Amazon, will not fit. Classic Warlock pickup truck with a 6 liter engine and a displacement of 1500 lbs. However, since there were no other options on Amazon, I tried this and it worked perfectly. The most important thing to keep in mind is that the truck has a FEMALE 4 spade connection (under the dash above the gas pedal) while this wire adapter has a MALE 4 spade connection. There are female wire harnesses as well, so keep an eye out.
So, my "buddy" just finished assisting with a brake job that was a pain in the neck. As I previously stated, the next step is to install my brake controller. "No way, no how, I'm not going to help with the wiring for any amount of money," he said. " So I installed the bracket and plugged the adapter into the back of the adapter, which was already plugged into the existing harness under the dash. I called my buddy five minutes after I got home to let him know everything was finished. It was a piece of cake.
On my 2017 RAM 1500, it was a perfect fit.
This wire slid right into the grey end of the dash's existing wiring. There was no need to remove any trim because it is just to the left of the brake pedal. It is not difficult to locate. The other end was connected to my Tekonsha Prodigy (first generation). Brake controller (90185). One screw at the bottom of the dash was removed, and the mounting bracket from the brake controller was used to replace it. Location is fine, but there is no drilling or additional hardware. br>br>The only thing I couldn't figure out was how to get this wire harness off the truck once it was installed. Even with the clip pulled back, it doesn't appear to be easy to separate, and I'm afraid I'll break something. Hmmm.
This enables you to use a Tekonsha P-Series product. 3 brake controller to a vehicle that does not already have one, or as an add-on to replace a faulty integrated factory controller. If you have two wire harnesses, this will only replace one of them in some cases. It will work fine, but your vehicle may believe there is a problem because it cannot detect the factory controller, prompting you to check the brake controller on the dashboard.
In a 2006 Ram 3500 Diesel Pickup, this wire adaptor will not work. up Truck. I'm a good match for the 90195- The P3 controller is compatible with the Truck wire harness, but it requires a Male Horizontal 4 wire plug rather than the square one. It's the 3020, I believe. Tekonsha P Brake Control Wiring Adaptor Regrettably, I purchased a 3021-based product. I'm stuck with P, but I'm going to go out and get a 3020- P in order to make the trailer brakes work properly.
You can skip this step and splice your wires with the controller's harness, but this makes the controller plug and play. It's possible that you'll spend more time contorting yourself to get under the ash than actually installing this. Depending on where you mount the control, you may need a zip tie or two to manage the extra wire length.
The plug is taped in gray foam underneath your dash, as you can see. That's where the plug is plugged in.