(3 Sticks) Kirkey Black Roll Bar Padding 1-1/2" to 1-7/8" Tubing -99001
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There's a lot of padding in that room, so I would say it's pretty high density. When I push on my roll cage through the foam, I cannot feel it.
No SFI rating is available for this item.
The length of the plants seems to be about 3 feet.
Can you please tell me how big the corners are? They will go on a Jeep roll cage that I'm building. Two inches of OD are on my jeep bars. It is most common to be The number five. Buying these was a no-brainer since they were the largest IDs that They will be fine if I cover them with outer covers. You can cut slices 1/4 or 1/2 inch from the inside and then extend them a bit farther if you need a bit more width or radius. It would be better if more cuts were made, but the depths would be shallower. Choosing too deep of a cut may cause low spots.
Selected User Reviews For (3 Sticks) Kirkey Black Roll Bar Padding 1-1/2" to 1-7/8" Tubing -99001
It is made from a 2" tube custom built for me. As far as I can tell, this is the only padding that fits.
There is a metal frame in my IKEA futon that is exposed (the mattress covers it by 1 Because I was banging my shin on the frame, I purchased these as a cushion The length is the same as an ordinary full bed (just a little longer but not nearly as long as a queen bed). of them stretched across the frame, and so far it has been working well. The overall length of the dress is good, though a few inches are uncovered. Product seemed very sturdy, and did not break when I bent it a little to fit in.
Fits a 1 3/4" tube but does not fit on a 2" tube.
Almost all of them were left with long, shallow lines of vacant material somewhere on them because they were either not inserted far enough into the mould or because a defect was present Here are some facts about The dimensions are 5 inches wide by 1/4 inch deep by 20 inches In keeping them I was using them for cushioning when I was carrying kayaks, so it might effect the cushioning. I was using them to hold kayaks, but my view is that it could affect cushioning. If I am going to buy a roll bar, I will pick a higher quality part.
It measured 35 inches in length. There was about a 1/4" gap between the foam and the cage on 1"3/4 Roll cages. A 35" stick was all that was needed for each. It is important to be aware when you are searching for exact 36". I like the foam because it's really dense. Hole locations were offset towards the side of the cut, resulting in an extra thick padding on the side.
It did not work for me when I bought it for use as jeep padding. Their thickness is greater than necessary and won't be able to effectively complete the bars. When they're on, the zip of your skin will not work!.
I needed it to do the job I needed it to do and it did it.
I found the fit to be tight, which was I am using a Poison Spyder roll cage and the harness bar for my Jeep JKU. 'Bone your noggin' twice and you are going to buy these'.