Three Bond Engine Silcone Gasket 1211 - 3.5oz. TB1211
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As a gasket replacement tool, it works great. To make sure the surfaces are flat, make sure they're absolutely Though this stuff is very good, it is quite It would also be a good idea to let it skin for a bit before following the instructions. The cure must be allowed to take place for a day before filling with oil, and that goes for all kinds of oil used
In my opinion, not very often, never used in the engine, very good for the transmission
A tube of toothpaste. While I did my entire transmission, I still had a lot left over. It's been over a year since the leaks started, and none have appeared since then. You are doing great work.
This process requires a set amount of time but is comparable to caulking at the same
Selected User Reviews For Three Bond Engine Silcone Gasket 1211 - 3.5oz. TB1211
Approximately every 2000 miles, the cam shims on my 1978 Kawasaki KZ1000 A2 required inspection by a motorcycle shop that repaired it. This motor had a hotrod motor installed and it needed to be serviced thoroughly every 2000 miles. A new gasket did not seem to do the trick. The valve cover had to be removed, KZ 1000 engines have always had valve cover leaks! Using this product is super easy, simply apply it very lightly to the gasket, and the leak will be sealed until it is taken apart again. You really need to try it! This is a great way of taking off the gasket most of the time without it sticking to the part it seals! My differential covers on my Jeep are now protected with it. It is important to remember that a light coating is best for this product! Let me know if this was helpful to someone!.
My BMW engine rebuilt after it was sprayed with this sealant and I did not use any BMW sealant despite BMW's advice. In light of how bad their engines leak oil, I think most of them do not have much room for discussion. For about a year following the rebuild, I didn't have a drop of oil leak out. ***Tip *** The surfaces need to be thoroughly cleaned with acetone or something similar. Once you have applied the first coat, apply the next very thinly. It is possible to spread a nice even coat using a small paintbrush. The lotion should not be slathered on thick. As thin as you can make it is what you need. It is also recommended to let the area sit a few days before making any type of use. The stuff does not dry as quickly as I would have liked, but that was the least of my worries.
As far as I'm concerned, it seals my VR engine cases and gaskets better than any other sealant I've Yamabond is exactly what we used to have, but they don't make it any longer. I have used it on metal to metal and gasket to metal deals with no problems.
I have tried four different product flavors for sealing 2 stroke cases over the years, and this is by far the best of them, more so than the three bond flavors I have tried before.
What have I been doing with this stuff all my life? You can use it to put air in I have been using these VW case halves together for years, best stuff ever!.
You can use it very sparingly since it takes about 15 minutes to set up.
It was a little expensive, but a great product. When the three bonds are pressed together, they seem to expand within a few minutes. This seal is awesome!.
It takes a little longer for it to set up than I originally anticipated but once it does, it's easy to clean up and I'm happy with the.