Craftwell EBMAG eBosser Magnetic Shim, 3-Pack , Black
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The magnet needs to be trimmed in half. Increasing the width to 11 inches
My guess is that you mean the magnet sheet. It might be that you just had the cutting side down, after all this mat was intended to use to hold your dies and cut your items. Flat side down says you should put the dies on the mat, not the cutting side have all had this experience at some point - I've committed this mistake way more times than I can remember! Past experience has shown that you can still use the mat after it has been damaged with a good tape over the cut. I hope you found this helpful. If you have any further questions, please let me know Please forward [email protected]. Please visit www.com. I'd like to send my regards to Cat
I have never seen an Evolution die cutting machine, so I am not sure.
It's hard to say. A platform measuring 8 1/2 x 11 is available for the Big Shot? Although I bet you can make it In that case, I would say yes if you already use a magnetic sheet with your Big Shot. Here's hoping this helps you in some way.
Selected User Reviews For Craftwell EBMAG eBosser Magnetic Shim, 3-Pack , Black
Even though this product did not have the name brand I had wanted, it was of equal quality and a better value than the one I had wanted.
It is great to work with them. Your dies should be held in place quite securely. You'll have to make sure that your die cutting side is up or you'll end up cutting This has happened to me and makes me a very unhappy camper, especially when I had to replace the We like the fact that you get 3 shims in one package for a more than reasonable.
do the job they're supposed to do, but they don't last. Thanks to their poor quality, we will have to replace them so The dies leave an impression on the mat each time they are used, which leaves impressions on your projects as well.
You'll find these magnetic sheets in your Cut & Paste package just like the ones that came with it I'm the boss. will occasionally have to cut through the mats, so you WILL need more of them.
It is a good substitute for Gemini die cutting machines. I would buy it.
This magnetic shim is much better than the one that came with my machine, so I was glad to find it. And I am glad to know I am not alone in ruining their shimer. I like that I have three since I could possibly tear this up again by putting the die in the machine the wrong way!.
Despite the magnetic sheet being very thin, it is still very cumbersome to use. As a replacement for the shim in my Ebosser, I purchased it and it will work perfectly for me. The sheets are too flexible to hold my dies, so I originally thought I could use them to hold my dies.